M400 will not boot into CNC10
Moderator: cnckeith
-
cobra18t
- Posts: 1
- Joined: Sat Nov 25, 2023 3:55 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: No
- CNC11: No
- CPU10 or CPU7: Yes
M400 will not boot into CNC10
I was trying to configure a network device on YaST and then restarted the machine. When it rebooted, it did not boot into CNC10 and had a different desktop look altogether. It looks like it is the ICEWM environment. I can open up a file manager and see that everything is still there, but I cannot figure out how to restart CNC10 and autoboot into it again. Any ideas?