off brand MPG
Moderator: cnckeith
-
- Posts: 15
- Joined: Sat Feb 03, 2018 11:42 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: K102811
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
- Location: Fowler MI
off brand MPG
I was given an MPG and want to use it on my ALLIN1DC. I bought a cable and round connector. I do not want to wire it incorrectly and would like someone review what I think the wiring should be. with this MPG I have three wires I think should connect to the common pin and would like this verified. The hand written wire numbers is the connector assignment I believe they go.
- Attachments
-
- ALLIN1DC MPG connections.pdf
- (177.32 KiB) Downloaded 16 times
Re: off brand MPG
That looks correct, except possibly for the LED.
I think the Allin1DC MPG output is an open-collector output that closes to 0V/COM. So you would connect the plus side of your LED to pin 1 (+5V), and the minus side to pin 14 (LED out).
I think the Allin1DC MPG output is an open-collector output that closes to 0V/COM. So you would connect the plus side of your LED to pin 1 (+5V), and the minus side to pin 14 (LED out).