One thing I have not been sure on is the amp rating of my servo motors. I have been just running it with what was default from teh setup (switches and software). Here is the info on the servo motors:
Sem X Type MT 30R4-42 serial NoE 8389, Constant Stall torque 29lbs in tenv, Max RPM 3200 volts 135, pulse amps 52, tacho 7 volts/1000 RPM, insul F, Perm Magnet DC Servo motor F87-70888, serial number 18920
I have not seen any info that say 9amps, 12amps, 15amps like the tuning documentation says. I also have not seen a "T" number anywhere.
Any advice?
Mikie
How to verify amp rating of my SEM servo motors?
Moderator: cnckeith
-
- Posts: 114
- Joined: Wed Sep 11, 2013 1:31 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 0916130849
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
How to verify amp rating of my SEM servo motors?
Mikie in Bloomington IL
-
- Posts: 91
- Joined: Thu Oct 17, 2013 4:32 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: 0605130770
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: How to verify amp rating of my SEM servo motors?
http://www.sem.co.uk/fileadmin/data/fil ... Manual.pdf
All the info is in there... full tech specs.
MT-30 is the 't' number
Yours are rated at about 42 amps at peak torque.
Lloyd
All the info is in there... full tech specs.
MT-30 is the 't' number
Yours are rated at about 42 amps at peak torque.
Lloyd
-
- Posts: 431
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: How to verify amp rating of my SEM servo motors?
The ALLIN1DC is typically set to 12 amps when it ships out, unless other servo info is provided. The setting is for the continuous stall current as opposed to the peak. Your servos appears to be in the 9 amp range.
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)