TCPC
Moderator: cnckeith
-
converterking
- Posts: 129
- Joined: Fri Mar 19, 2010 2:38 pm
TCPC
Does Centroid have any future plans to offer tool center point control as an option?
-
cbb1962
- Posts: 349
- Joined: Wed Jan 03, 2018 10:04 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 38D2695C8301-0122180576
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: NW Arkansas
Re: TCPC
from the CNC 12 V4.14 Manual Page 218
12.17 G43.4 - Rotary Tool Center Point (with G43.3 Compensation)
When G43.4 is active then any feed move (G1) will be made such that the tip of the tool moves in a
straight line (this typically causes the Z-axis to move up and down during the move). G43.3 Compensation
applies in this mode.
Clint in NW Arkansas
The more I learn, the more I realize I don't know...
The more I learn, the more I realize I don't know...