Centroid Community CNC Support Forum

I have a Adavance Motion control Serco 30A8T and a 50A8T to run Glentek GM450 38 and GM6060 50 motors , now I need to find a power supply for the drives I need 80 volts Dc pri voltage is 120 or 208 Ac . Where could I find A transformer or power supply to do the job?

Andrea

Our power supplies output 110vdc. If this is acceptable you could buy one of ours.

Which can be found in 110vac or 220vac on the following page:
http://ajaxcnc.com/cnc_components.htm

james188 wrote:Which can be found in 110vac or 220vac on the following page:
http://ajaxcnc.com/cnc_components.htm

Can I run these boards with this power supply since they have a 80V Dc limit/ what is the dc voltage on these power supplys?
Adavance Motion control Serco 30A8T and a 50A8T

Sorry for the confusion. Our power supply outputs 110VDC. IF you need 80VDC you need another power supply.

I have a 130V powersupply but I need a 80v for the drives, and I can't seem to be able to find one.

Andrea

You should be able to call a transformer manufacture and get a custom wound transformer that will supply the appropriate AC voltage to rectify to 80DC with a cap and bridge.