Limit switch problem <resolved>
Moderator: cnckeith
-
greenacres36
- Posts: 2
- Joined: Sun May 05, 2024 12:59 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: Yes
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Limit switch problem <resolved>
I am installing a new allin1dc on a Bridgeport BTC1. The limit switches on the Z axis work perfectly. But the X and Y Will not let you reverse the direction once they are tripped. They show an axis overload and you have to either hand crank off the axis or disable the limit switches on the board to continue. Nothing is bound up and you can turn them very easily. There must be something in the parameters for such that is wrong on those two axis. I’m stumped.
-
greenacres36
- Posts: 2
- Joined: Sun May 05, 2024 12:59 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: Yes
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Limit switch problem
Never mind, I figured it out. I should’ve done a search first, but I had access reversal on two axis. I switched them around now at homes correctly.