How to make CNC12 require two cycle start presses before you get automatic motion.

Moderator: cnckeith

Locked
cnckeith
Posts: 605
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
System Serial Number: none
Contact:

How to make CNC12 require two cycle start presses before you get automatic motion.

Post by cnckeith » Tue Jan 23, 2018 2:01 pm

How to make CNC12 require two cycle start presses before you get automatic motion.
F1 setup, F3 Config, F1 Control, "Jog panel required" set to "Yes" press F10.

now, cycle start once loads the Gcode..no motion... cycle another time..now you get automatic motion.

https://youtu.be/NPldA1EVumU


youtu.be/NPldA1EVumU

Locked

Who is online

Users browsing this forum: No registered users and 1 guest