Once you download and install TeamViewer, follow this short video to setup a permanent password.
TeamViewer is used for remote PC access. Normally used for Support Staff to remote into your CNC PC to check your configuration if so requested.
1 post • Page 1 of 1
- Posts: 954
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- MPU11 & GPIO4D -w/ 3rd Party Drives: No
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
- System Serial Number: none
- Location: Mesa, AZ
"Jack of all trades, master of none!"
Who is online
Users browsing this forum: No registered users and 1 guest