When the Centroid CNC Software Loses its Acorn (resolved)

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
Posts: 66
Joined: Sat May 27, 2017 2:12 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
CNC11: No
CPU10 or CPU7: No
System Serial Number: none
Location: Phoenix, AZ

When the Centroid CNC Software Loses its Acorn (resolved)

Post by RGSparber » Fri Sep 15, 2017 10:00 am

Recently my new Centroid Acorn CNC system started to complain. After receiving help from Centroid plus doing some poking around, I found a double fault. Somehow a virus program had been installed and was active. I also bumped the Ethernet cable and it was not making full contact. All is well again. This was not a hassle, it was an opportunity to write up my debugging steps.

If you are interested, please see


Your comments are welcome. All of us are smarter than any one of us.



Post Reply

Who is online

Users browsing this forum: GraemeP, Tapburrbit and 1 guest