Outputs 9-16 on an Acorn Six

rguertin · Post by **rguertin** » Wed Jan 17, 2024 5:46 pm

Where in the volumes of information do you find something about these outputs. I've read the mill manual from the 1st page to the last, could not find any info about these outputs. What got me started is I was trying to use the Wizard to address OUTPUT 15, it's not in there. Am I missing something?

ShawnM · Post by **ShawnM** » Wed Jan 17, 2024 5:59 pm

Did you by chance read the Acorn 6 install manual? Did you install the correct software for Acorn 6 and not Acorn?

Post by **cnckeith** » Wed Jan 17, 2024 6:32 pm

rguertin wrote: ↑Wed Jan 17, 2024 5:46 pm Where in the volumes of information do you find something about these outputs. I've read the mill manual from the 1st page to the last, could not find any info about these outputs. What got me started is I was trying to use the Wizard to address OUTPUT 15, it's not in there. Am I missing something?

screen shot please.

rguertin · Post by **rguertin** » Thu Jan 18, 2024 12:12 pm

ShawnM wrote: ↑Wed Jan 17, 2024 5:59 pm Did you by chance read the Acorn 6 install manual? Did you install the correct software for Acorn 6 and not Acorn?

Maybe I should check the installation manual, I did ot think it would be in there. Thanks ShawnM

Centroid Community CNC Support Forum

Outputs 9-16 on an Acorn Six

Outputs 9-16 on an Acorn Six

Re: Outputs 9-16 on an Acorn Six

Re: Outputs 9-16 on an Acorn Six

Re: Outputs 9-16 on an Acorn Six