Acorn board up in smoke and z axis no longer works
Moderator: cnckeith
-
- Posts: 153
- Joined: Wed Sep 06, 2017 1:52 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: Acorn board up in smoke and z axis no longer works
Centroid Customer Service regarding updating Acorn license. Summery they are great. I had a problem with my Begalboard and had to replace it. Pilot error nothing Centroid did. As advised by CS I bought a replacement and then did the un-bricking procedure as described by Marty sent them a report they then sent me a new license and all was up and running as expected. great service and support. I am on my 5th system and planinng on doing more
-
- Posts: 136
- Joined: Wed Jun 20, 2018 1:12 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: Acorn board up in smoke and z axis no longer works
Well low and behold i successfully repaired the control and its back up running. I’ve done a lot of iron soldering over the years but this was a first smd. Had everything here and it cost me under $10 to fix. It’s not pretty I had one pcb tab pull up for whatever reason it was near the center. So the hot air worked good for the install and I went back in and repaired the one terminal and cleaned the other next to it as good as I could. Not an expert by any means but she is working solidly now all 3 axis fully functional. I didn’t have any wicking sticks here so i did leave the old solder on to and applied a light amount of liquid solder over the top. Only difficulty was setting the gate array on top of solder bumps and keeping it there while I heated it up.
-
- Posts: 52
- Joined: Wed Nov 23, 2011 11:04 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: K2019,K1110
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: Yes
- Location: Finger Lakes, NY
Re: Acorn board up in smoke and z axis no longer works
Did you find the issue that caused the gate array to fry?
-
- Posts: 9914
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: Acorn board up in smoke and z axis no longer works
Yes, good question. What caused the damage?
Even if it was a mistake, people can learn from it.
Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ