Under v4.12 I was able to run a maximum of 300 IPM on my knee mill with DYN4 servo drives. When I try to change maximum speed setting in the wizard for v4.14, it will not allow me to enter 300 IPM, a pop-up window says only allow a maximum of 150 IPM is allowed. I am running the "free" version for setup, if that matters.
Is this a new limit?
150 IPM limit with v4.14? ( Resolved )
Moderator: cnckeith
-
- Posts: 2190
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
Re: 150 IPM limit with v4.14?
What are your current and previous pulse per second settings? The default has changed in case you missed it
-
- Posts: 793
- Joined: Thu Apr 12, 2018 11:16 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: 150 IPM limit with v4.14?
I had to get everything setup and reboot the controller then go back and up my rapids.