I started working on my configuration with the the Acorn Wizard and found that if I select All-Limits for any of the 8 inputs, it will result in a PLC compile error. I am able to configure any of the 8 input to use as All-Homes.
Could this be a bug in the wizard?
Wizard will not allow All-Limits - PLC compile error
Moderator: cnckeith
-
- Posts: 7334
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Wizard will not allow All-Limits - PLC compile error
yes, its been covered here on the forum elsewhere,
use homeall and software travel limits, that works.
v4.14 will have the limitall fix.
use homeall and software travel limits, that works.
v4.14 will have the limitall fix.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html