Centroid Community CNC Support Forum

Posted: **Tue Feb 20, 2018 9:12 pm**

Hello!

getting ready to convert to ACORN from my mach3 kASUGA knee mill conversion-

is it possible with Acorn to sense spindle RPM and then adjust feedrate acordingly (with some math)?

thank you!

Posted: **Wed Feb 21, 2018 11:10 pm**

Feed per revolution!
If you have an encoder on the spindle it works like a charm!

Posted: **Thu Feb 22, 2018 6:57 am**

Yes. Parameter 78 can be configured to either wait for the spindle to each programmed speed before axes move and/or adjust the axes feedrate up/down as the spindle slows or speeds up due to load conditions

Centroid Community CNC Support Forum

ACORN - REAL-TIME feed rate adjustment from spindle RPM

ACORN - REAL-TIME feed rate adjustment from spindle RPM

Re: ACORN - REAL-TIME feed rate adjustment from spindle RPM

Re: ACORN - REAL-TIME feed rate adjustment from spindle RPM