Page 1 of 1
Acorn Step/Dir Differential line driver
Posted: Sun Feb 18, 2018 4:29 pm
by jmaks
I have the yaskawa SGDS servopacks, and the drive will only accept line driver step/dir, Is there a way i can interface them to the Acorn?
thanks
Re: Acorn Step/Dir Differential line driver
Posted: Sun Feb 18, 2018 5:59 pm
by Gary Campbell
Since the board terminals are open collector output, I would suggest using the DB25 step & direction terminals
Re: Acorn Step/Dir Differential line driver
Posted: Mon Feb 19, 2018 8:15 am
by jmaks
Thank you Gary, i didn't realize the DB25 was 5 Volt, i will be using the DB25 with this
https://cnc4pc.com/differential-line-driver.html, my Acorn is arriving tomorrow i will post how it works out.
Re: Acorn Step/Dir Differential line driver
Posted: Tue Feb 20, 2018 9:05 pm
by jmaks
It works just fine, thank you
Re: Acorn Step/Dir Differential line driver
Posted: Fri Feb 23, 2018 11:48 am
by cncman172
I also use the DB25 signals for Step/Direction outputs and open collector outputs for Drive Enable, etc. I ended up milling a little PC board and just soldered the differential driver ICs. Works perfect.
Russ