Page 1 of 1
Gecko Drive servos
Posted: Thu Feb 01, 2018 11:17 pm
by lvanduyn
I use the Gecko drive 320 step and dir servo drives. I see connection diagrams for the 201 and 203 stepper drives
but nothing for the 320 or 340. Is it possible to use the 320 drives with the Acorn board ?
Larry
Re: Gecko Drive servos
Posted: Fri Feb 02, 2018 10:52 am
by Centroid_Liviu
Larry,
Those drives have step + direction so no issue. You will need a dual voltage 24v and 5v power supply. While we don't have schematic for every drive out there (yet....) as long as they accept step + direction it should work.
Re: Gecko Drive servos
Posted: Fri Feb 02, 2018 8:42 pm
by martyscncgarage
lvanduyn wrote: ↑Thu Feb 01, 2018 11:17 pm
I use the Gecko drive 320 step and dir servo drives. I see connection diagrams for the 201 and 203 stepper drives
but nothing for the 320 or 340. Is it possible to use the 320 drives with the Acorn board ?
Larry
Suggest you use the G201 schematic as a guide.
Marty