Centroid Community CNC Support Forum

Posted: **Mon Feb 05, 2018 3:20 pm**

eng199 wrote: ↑Mon Feb 05, 2018 2:01 pm Let me try to clarify the instructions:

See if the 5V regulator is working:
*Locate D2 pin 2. See the photograph on page 2 in the document linked to this post: viewtopic.php?f=60&t=1470.
*Plug in ACORN +24VDC and COM, but nothing else
*Measure from D2 pin 2 to COM. The measurement should be 5V.

There is no need to repeat the procedure in the document.

Marty, can you say with any confidence that "D2=0V" was the result of the procedure given previously? Troubleshooting on speculation is not productive.

transmon is getting an RMA to return his ACORN, so he may not even return to this thread.

I only quoted what he had posted.
My apologies Matt.
I will let you handle these things.

Posted: **Mon Feb 05, 2018 4:13 pm**

No problem Marty. Be careful to not get blown off course by unclear answers.

Posted: **Fri Feb 09, 2018 1:41 am**

Haven't been able to get RMA as of today, I spoke with someone on monday about it I purchased another Acorn board and sent the serial number of my old one my new one works but cant use paired axis because the new one won't take my pro license so cant use my machine will someone please let me know what I have to do to get this resolved Thanks Dave.

Centroid Community CNC Support Forum

Acorn wont take flash no heart beat when on board

Re: Acorn wont take flash no heart beat when on board

Re: Acorn wont take flash no heart beat when on board

Re: Acorn wont take flash no heart beat when on board