Eithernet cable
Moderator: cnckeith
-
- Posts: 3
- Joined: Mon Nov 13, 2017 3:59 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Eithernet cable
What are the cat ends that plug into the all in one board and the other parts for the shielded eithernet cable?
-
- Posts: 430
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Eithernet cable
It is a RJ-45 Shielded CAT5E cable and jack. Are you trying to make your own? We sell Ethernet Cable in various lenghts, you can also source it all over the internet, as long as its Shielded CAT5E or above it should work.
If you are looking to build your own I have attached a Technical Bulletin with the full details.
If you are looking to build your own I have attached a Technical Bulletin with the full details.
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)