Connecting Acorn to Micro 1 driver from an old CNC 4

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
Sroane42
Posts: 1
Joined: Mon Jan 15, 2018 1:12 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: No
CPU10 or CPU7: No

Connecting Acorn to Micro 1 driver from an old CNC 4

Post by Sroane42 »

Does anyone know how to wire the Micro 1 driver board to the Acorn board?
Centroid_Liviu
Posts: 428
Joined: Mon Jul 18, 2011 9:57 am
Allin1DC CNC Controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes

Re: Connecting Acorn to Micro 1 driver from an old CNC 4

Post by Centroid_Liviu »

Please take a look at the attached document below for the Pin-Out on the Micro 1 side. You can use the Acorn Standard Schematic for the rest of the hookups.
Attachments
MICRO1_PINOUT.DOC
(34.5 KiB) Downloaded 94 times
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043

Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.

(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Centroid_Tech
Posts: 286
Joined: Thu Mar 18, 2010 2:24 pm

Re: Connecting Acorn to Micro 1 driver from an old CNC 4

Post by Centroid_Tech »

You do not have to worry about pins 24, CPUVCC, and 26, CPUGND, as the items that use those signals are most likely not even populated on the MICRO1 board.
When requesting support, please ALWAYS post a current report. Find out how to take a report from your Acorn, CNC11 or CNC10 system here: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.

If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.

Without the above information we may not be able to help and/or reply until the required information is posted..
Post Reply