Connecting Acorn to Micro 1 driver from an old CNC 4
Moderator: cnckeith
-
- Posts: 1
- Joined: Mon Jan 15, 2018 1:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Connecting Acorn to Micro 1 driver from an old CNC 4
Does anyone know how to wire the Micro 1 driver board to the Acorn board?
-
- Posts: 428
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Connecting Acorn to Micro 1 driver from an old CNC 4
Please take a look at the attached document below for the Pin-Out on the Micro 1 side. You can use the Acorn Standard Schematic for the rest of the hookups.
- Attachments
-
- MICRO1_PINOUT.DOC
- (34.5 KiB) Downloaded 94 times
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
-
- Posts: 286
- Joined: Thu Mar 18, 2010 2:24 pm
Re: Connecting Acorn to Micro 1 driver from an old CNC 4
You do not have to worry about pins 24, CPUVCC, and 26, CPUGND, as the items that use those signals are most likely not even populated on the MICRO1 board.
When requesting support, please ALWAYS post a current report. Find out how to take a report from your Acorn, CNC11 or CNC10 system here: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.
Without the above information we may not be able to help and/or reply until the required information is posted..
If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.
Without the above information we may not be able to help and/or reply until the required information is posted..