Router related questions.

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
jazzcnc
Posts: 34
Joined: Mon Jan 01, 2018 8:23 am
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: No
CPU10 or CPU7: No

Re: Router related questions.

Post by jazzcnc »

martyscncgarage wrote: ↑Sun Feb 04, 2018 5:25 pmTake a look at Patrio's machine. While I can't see under the table, I guess I would have to test it to see if it did as you guys suggest. I find it hard to believe it would deflect that much given the cutting forces. Now if the frame/gantry were of less rigid design/material, I could see that being a factor
Marty, If that machine uses a Single screw and doesn't deflect I'll jump on a plane, climb the statue liberty and show my Arse to the whole of America.!! . . . . Trust me you don't want too and ain't going to see that..Lol
Top
DICKEYBIRD
Posts: 536
Joined: Sat Jul 08, 2017 7:38 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: n/a yet
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
Location: Collierville, TN USA

Re: Router related questions.

Post by DICKEYBIRD »

jazzcnc wrote: ↑Mon Feb 05, 2018 2:15 pmMarty, If that machine uses a Single screw and doesn't deflect I'll jump on a plane, climb the statue liberty and show my Arse to the whole of America.!! . . . . Trust me you don't want too and ain't going to see that..Lol
Ewww, how are we supposed to un-read THAT? :roll: :lol:
Milton in Collierville, TN

"Accuracy is the sum total of your compensating mistakes."
Top
Post Reply

Return to “Centroid Acorn CNC Controller”