CNCWizard won't run after install- (resolved)
Posted: Wed Dec 06, 2017 6:46 am
Hi,
I have just purchased an Acorn board and the pro mill version. 4.08
After installing and setting up for benchtesting according to the guidelines, I can't get the CNCWizard to run.
I seems to be starting, I get a hourglass for a moment, but nothing happens.
I have now tried 3 different computers running windows 10 x64 - None of them is working.
I then began to investigate the issue, and it seems to somehow being related to the "cncm.prm.xml" file.
If I edit this xml file and remove most of the entries, only leaving 20 or so. The CNCWizard is able to start, but if I hit the "reset all settings" button in the CNCWizard it crashes. CNCWizard resets "cncm.prm.xml" which now again contain the 1000 entries. But after this I have the same issue, CNCWizard won't start.
Please advice where to go now
I have just purchased an Acorn board and the pro mill version. 4.08
After installing and setting up for benchtesting according to the guidelines, I can't get the CNCWizard to run.
I seems to be starting, I get a hourglass for a moment, but nothing happens.
I have now tried 3 different computers running windows 10 x64 - None of them is working.
I then began to investigate the issue, and it seems to somehow being related to the "cncm.prm.xml" file.
If I edit this xml file and remove most of the entries, only leaving 20 or so. The CNCWizard is able to start, but if I hit the "reset all settings" button in the CNCWizard it crashes. CNCWizard resets "cncm.prm.xml" which now again contain the 1000 entries. But after this I have the same issue, CNCWizard won't start.
Please advice where to go now