Page 1 of 1

Intercon for lathe training video?

Posted: Tue Dec 05, 2017 3:23 pm
by DICKEYBIRD
I haven't been able to find one (other than a in foreign language) and was hoping someone knows of one. Is there one on the Centroid website & I just overlooked it?

Re: Intercon for lathe training video?

Posted: Tue Dec 05, 2017 4:07 pm
by cnckeith
Marty is going to make a fresh one using his Acorn equipped Emco 120.

In the meantime the lathe operator manual has step-by-step tutorials for intercon check them out also the section on setting up tool offsets is pretty good and steps you through that as well

Re: Intercon for lathe training video?

Posted: Thu Dec 07, 2017 12:51 pm
by DICKEYBIRD
For anyone else that is trying to learn Intercon for a lathe, this video by Keith's younger brother Keith does a great job in this training video for mill Intercon. It cleared up most all of my befuddlement! :D

http://www.centroidcnc.com/cncvideo/vid ... step4.html