Page 1 of 1

New to the Centroid family

Posted: Mon Dec 04, 2017 12:21 pm
by jcarver
Hello everyone,

Yesterday I purchased the Acorn board. I'm new to CNC's in general and just recently built a PM25MV with 620oz Clearpath SDSK servos. Like many I defaulted to Mach3 only to get fed up spending more time troubleshooting than actually making parts :( . In my search for a more commercial based software I found Centroid and their new Acorn board. Once I get the board I'll post up the results of my switch.

Here's a picture of her, admittedly a little dirty.

Image

Re: New to the Centroid family

Posted: Mon Dec 04, 2017 12:27 pm
by DICKEYBIRD
Welcome aboard! Dirty, nah...purposeful, yes!

Re: New to the Centroid family

Posted: Mon Dec 04, 2017 12:28 pm
by cnckeith
nice, thanks for posting..please watch all of marty's great install videos found here.
http://www.centroidcnc.com/centroid_diy ... guide.html

Re: New to the Centroid family

Posted: Mon Dec 04, 2017 1:20 pm
by jcarver
cnckeith wrote:
Mon Dec 04, 2017 12:28 pm
nice, thanks for posting..please watch all of marty's great install videos found here.
http://www.centroidcnc.com/centroid_diy ... guide.html
Will do, thank you.

Re: New to the Centroid family

Posted: Mon Dec 04, 2017 8:26 pm
by frijoli
I lik'em a little dirty.
You will be happy with the Centroid interface.

Re: New to the Centroid family

Posted: Wed Dec 06, 2017 12:09 pm
by martyscncgarage
frijoli wrote:
Mon Dec 04, 2017 8:26 pm
I lik'em a little dirty.
You will be happy with the Centroid interface.
Indeed, dirty and swarfy means they get used!
+1 on the Centroid interface (and hardware!)

Marty