Page 1 of 1

Dual spindle router

Posted: Sun Nov 12, 2017 12:49 pm
by dbunyip
Lioking for more info on how to configure my routers dual spindles. Just purchased acorn for it to replace the garbage thing it came with and trying to plan and prep for fastest change over and haven't seen one of these done yet but was told on cnczone that it was no problem to do. The current controls call spindles as tool numbers to swap (one spindle t1 other t2). Thinking ahead if this works as well as I hope I want to use on a plasma with marking pen and engraving in a similar fashion