Dual spindle router

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
dbunyip
Posts: 9
Joined: Sun Nov 12, 2017 12:08 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No
System Serial Number: none

Dual spindle router

Post by dbunyip » Sun Nov 12, 2017 12:49 pm

Lioking for more info on how to configure my routers dual spindles. Just purchased acorn for it to replace the garbage thing it came with and trying to plan and prep for fastest change over and haven't seen one of these done yet but was told on cnczone that it was no problem to do. The current controls call spindles as tool numbers to swap (one spindle t1 other t2). Thinking ahead if this works as well as I hope I want to use on a plasma with marking pen and engraving in a similar fashion

Post Reply

Who is online

Users browsing this forum: Commotion and 1 guest