New install - CNC12 (resolved, follow the video)

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

DICKEYBIRD
Posts: 536
Joined: Sat Jul 08, 2017 7:38 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: n/a yet
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
Location: Collierville, TN USA

Re: New install - CNC12 (resolved, follow the video)

Post by DICKEYBIRD »

Thanks for taking the time to go back & document your solution Scot. I had some issues making mine happy few a couple weeks ago & never did get it going. I gave it a rest & went back to other parts of the project for a while but I'm going to give it a shot probably this weekend. After seeing what your solution was, I think mine could very likely be the same thing. (...and yes Keith, I now have a 23" 16:9 monitor so I can see the VCP! :oops: )
Milton in Collierville, TN

"Accuracy is the sum total of your compensating mistakes."
ScotY
Posts: 654
Joined: Sat Sep 23, 2017 7:57 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
Location: Honolulu, HI

Re: New install - CNC12 (resolved, follow the video)

Post by ScotY »

Hi Milton,

Hope you get your Acorn up and running. I haven't even scratched the surface but I like it a lot already. I want to try and get a motor hooked up to it on the bench tonight and see how that goes.
Post Reply