Marty, If that machine uses a Single screw and doesn't deflect I'll jump on a plane, climb the statue liberty and show my Arse to the whole of America.!! . . . . Trust me you don't want too and ain't going to see that..Lolmartyscncgarage wrote: ↑Sun Feb 04, 2018 5:25 pmTake a look at Patrio's machine. While I can't see under the table, I guess I would have to test it to see if it did as you guys suggest. I find it hard to believe it would deflect that much given the cutting forces. Now if the frame/gantry were of less rigid design/material, I could see that being a factor
Router related questions.
Moderator: cnckeith
-
- Posts: 34
- Joined: Mon Jan 01, 2018 8:23 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: Router related questions.
-
- Posts: 536
- Joined: Sat Jul 08, 2017 7:38 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: n/a yet
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: Collierville, TN USA
Re: Router related questions.
Ewww, how are we supposed to un-read THAT?
Milton in Collierville, TN
"Accuracy is the sum total of your compensating mistakes."
"Accuracy is the sum total of your compensating mistakes."