First cut using Centroid Acorn and a G code file
Posted: Sun Sep 10, 2017 5:37 pm
It is not much to see, but is a milestone to me. Lots of things worked perfectly for me to make this simple cut around a cube:
Home at the push of a button
Tool Touch Off to set tool height
Tool Offset via G code
X Box Controller
Part 0 with my Electronic Edge Finder which uses my Reference Tool
plus a few simple lines of G code in a file:
Rick
Home at the push of a button
Tool Touch Off to set tool height
Tool Offset via G code
X Box Controller
Part 0 with my Electronic Edge Finder which uses my Reference Tool
plus a few simple lines of G code in a file:
Rick