As a newbie to Centroid, I am drowning in extremely important information. It is very easy for me to forget some newly learned bit.
My solution is to bolt a small steel plate to the bottom of my monitor. I also have a roll of large packing stickers and a bunch of those sheets of soft magnetic material.
When I need to remember something, I slap a sticker on one of the sheet magnets. Then I trim to fit. The information is written on the face. The magnet holds it to the sheet steel until that lesson is learned. Then it is displaced by a new reminder.
Rick
A Small Life Preserver
Moderator: cnckeith
-
- Posts: 3098
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: A Small Life Preserver
Rick,
Since it's steel, just write on it with a Sharpie and then wipe it off with a little acetone and write your next message.
Tom
Since it's steel, just write on it with a Sharpie and then wipe it off with a little acetone and write your next message.
Tom
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.