A video of the Park and Home Functions

Post your completed retrofits for the world to see.

Moderator: cnckeith

Post Reply
Posts: 66
Joined: Sat May 27, 2017 2:12 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
CNC11: No
CPU10 or CPU7: No
System Serial Number: none
Location: Phoenix, AZ

A video of the Park and Home Functions

Post by RGSparber » Mon Sep 04, 2017 8:12 pm

This video shown the cutter relative to the table as it first goes to the Park position. Then I simulate power down and restart. The program then does a Home. The camera is position as if you were lying on the mill table looking up at the cutter. Don’t try this at home…

https://www.youtube.com/watch?v=DRH3-7y ... e=youtu.be


Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest