Thank you Gary Campbell

[Tlempicke]

Over the years you have always been generous with your help to this community. When my homemade Acorn Shopbot conversion got to the point where i could not remember what and when I had modified I decided that it was time for an overhaul. The control system you provided was easy to install and worked properly the first time I tried it. In addition the written instructions that you sent were great and saved me hours of time.
Thanks Gary, I literally couldn't have done it without you.

[gerald martin]

Yep, same here. Gary calls a spade a spade. Every once in a while, someone gets a little bit miffed by that. he's a gift to this community, all the same. Thanks Gary!

[cnckeith]

I drove down a to Vectric event many years ago to meet Gary who was demonstrating an Acorn equipped CNC Router with a Rotary table at the event.
Within minutes of meeting him I knew that Gary was one of us!

For anyone reading this, Gary's contact info is here.
https://www.centroidcnc.com/shopbot_gcnc.html