First cut using Centroid Acorn and a G code file

Post your completed retrofits for the world to see.

Moderator: cnckeith

Post Reply
RGSparber
Posts: 48
Joined: Sat May 27, 2017 2:12 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
System Serial Number: none
Location: Phoenix, AZ
Contact:

First cut using Centroid Acorn and a G code file

Post by RGSparber » Sun Sep 10, 2017 5:37 pm

It is not much to see, but is a milestone to me. Lots of things worked perfectly for me to make this simple cut around a cube:

Home at the push of a button
Tool Touch Off to set tool height
Tool Offset via G code
X Box Controller
Part 0 with my Electronic Edge Finder which uses my Reference Tool
plus a few simple lines of G code in a file.


youtu.be/ds4bxwzsyPA



Rick

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest