Error in RT-200 Manual wiring diagram?

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
tblough
Posts: 131
Joined: Tue Mar 22, 2016 10:03 am
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No
System Serial Number: 100505
100327
102696
Location: Boston, MA
Contact:

Error in RT-200 Manual wiring diagram?

Post by tblough » Tue Sep 26, 2017 3:03 pm

Page 32 (DC wiring) in the RT-200 manual shows Encoder common (blk/red) connected to pin D of the Amphenol connector. The home switch green wire is also connected to pin D on the Amphenol connector. Is this correct?
Cheers,

Tom
Confidence is the feeling you have before you fully understand the situation.

Centroid_Tech
Posts: 156
Joined: Thu Mar 18, 2010 2:24 pm

Re: Error in RT-200 Manual wiring diagram?

Post by Centroid_Tech » Wed Sep 27, 2017 10:37 am

That is correct because the return for the power for the encoder signals should be the same as the return for the power for your inputs.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests