CNC10 cannot load files

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
luiguicam
Posts: 1
Joined: Wed Aug 03, 2011 11:39 pm
Allin1DC CNC Controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: Yes
CNC11: No
CPU10 or CPU7: Yes
System Serial Number: none

CNC10 cannot load files

Post by luiguicam » Sat Sep 23, 2017 5:24 pm

Hello,
Please help, I had to replace the computer since the old one died. Now the new computer works pretty well but it doesn't recognize the netwok card or the USB devices, so i Cant load files into the memory. Any Ideas?


Regards,

diycncscott
Posts: 686
Joined: Thu Mar 04, 2010 4:03 pm

Re: CNC10 cannot load files

Post by diycncscott » Mon Sep 25, 2017 7:29 am

We need a report file (even an old one since your usb isn't working), serial number and/or System Id in order to help.

Does the computer you installed contain the EXACT same motherboard that was in the previous system? Did you replace the SSD as well? Did you purchase it from Centroid? What version of CNC10 are you running?

Linux Kernels are VERY sensitive to hardware changes. If your current motherboard is not and EXACT replacement, it is likely that it has chipsets that didn't exist when the Kernel was released and are therefore not supported.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests