alarm 916

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
mike
Posts: 4
Joined: Mon Sep 18, 2017 4:28 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
System Serial Number: 0615050824

alarm 916

Post by mike » Mon Sep 18, 2017 4:40 pm

Anytime i use the MDI I get this fault can you help me?
Attachments
20170918_155217.jpg
report.zip
(63.36 KiB) Downloaded 11 times

diycncscott
Posts: 686
Joined: Thu Mar 04, 2010 4:03 pm

Re: alarm 916

Post by diycncscott » Tue Sep 19, 2017 7:20 am

It says your estop is pressed.........................

mike
Posts: 4
Joined: Mon Sep 18, 2017 4:28 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
System Serial Number: 0615050824

Re: alarm 916

Post by mike » Tue Sep 19, 2017 8:23 am

The picture is just for the serial number I can run programs with no problem just when I try to use the MDI I to make a move to re zero I get this fault

Centroid_Tech
Posts: 156
Joined: Thu Mar 18, 2010 2:24 pm

Re: alarm 916

Post by Centroid_Tech » Tue Sep 19, 2017 8:54 am

It's most likely because parameter 11 is set to -14 rather than 14. From the main screen press F1(Setup)->F3(Config)->default password is 137->F3(Params). Change the value of parameter 11 and press F10(Save). See if that helps you out.

mike
Posts: 4
Joined: Mon Sep 18, 2017 4:28 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
System Serial Number: 0615050824

Re: alarm 916

Post by mike » Tue Sep 19, 2017 10:03 am

Parameter 11 is set to -14 rather than 14 ??

mike
Posts: 4
Joined: Mon Sep 18, 2017 4:28 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
System Serial Number: 0615050824

Re: alarm 916

Post by mike » Tue Sep 19, 2017 10:25 am

Nevermind normally open normally closed I read the manual thanks for the quick reply

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests