During some problem troubleshooting, the system test file was reset. The mill is fully functional, and all limit switches and travels are good to go, but I am unable to run the full system test due to having a trt32 table installed (no clearance with the b axis tower).
Is there a line that can be added to the output file to mitigate the error message at startup (some sort of "pass" rather than "failed"
Regards,
John
Startup error message for system test
Moderator: cnckeith
-
- Posts: 177
- Joined: Thu Jan 26, 2017 11:45 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 10583
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: Yes
- Location: North Carolina
-
- Posts: 7292
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Startup error message for system test
John,
Hello. yes. please email support@centroidcnc.com a fresh copy of the system report.zip file and they will help you out. thanks, Keith
Hello. yes. please email support@centroidcnc.com a fresh copy of the system report.zip file and they will help you out. thanks, Keith
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html