Page 1 of 1

Startup error message for system test

Posted: Thu Sep 07, 2017 3:30 pm
by Sportbikeryder
During some problem troubleshooting, the system test file was reset. The mill is fully functional, and all limit switches and travels are good to go, but I am unable to run the full system test due to having a trt32 table installed (no clearance with the b axis tower).

Is there a line that can be added to the output file to mitigate the error message at startup (some sort of "pass" rather than "failed"

Regards,
John
Startup_error_message
Startup_error_message

Re: Startup error message for system test

Posted: Fri Sep 08, 2017 8:21 am
by cnckeith
John,
Hello. yes. please email support@centroidcnc.com a fresh copy of the system report.zip file and they will help you out. thanks, Keith