Page 1 of 1

confused about option

Posted: Thu Aug 03, 2017 5:32 pm
by RGSparber
I see below: - Touch Screen Operator Control panel. <--- Does this mean it comes with a Touch Screen monitor?

Thanks,

Rick
______________________________
Use your own PC OR purchase a Centroid NUC CNCPC $799 (#11084)

Centroid Intel NUC CNCPC

- Preloaded with Windows 10 and pre-configured for CNC PC duty
- Preloaded Centroid CNC software Mill and Lathe
- G code Editor
- Intercon Conversational
- Stock PLC programs
- Touch Screen Operator Control panel. <---
- Intel I3 processor, 4GB ram, SSD (solid state drive)
- Display port, HDMI, Ethernet, USB
- Centroid tested and pre qualified to work with Centroid CNC controllers

Re: confused about option

Posted: Thu Aug 03, 2017 5:55 pm
by RGSparber
Sorry, but my confusion continues. I found these two products. The one recommended for the Acorn is $799 which is the same price as just the NUC sold by Centroid. Is that right?

the other offering looks very similar but costs $401 more.

Thanks,

Rick

http://www.centroidcnc.com/centroid_diy ... nents.html

Centroid all-in-one Touch Screen CNCPC ready to go : $799 (#12786)

- Preloaded with Windows 10 and pre-configured for CNC PC duty
- Preloaded Centroid CNC software with G code Editor,
Intercon, Stock PLC programs, Acorn Install Wizard, Touch Screen
Operator Control panel.
- 19.5" Touch Screen,4 GB ram, I3 processor
- Wifi, Ethernet, webcam with mic, card reader, usb ports
- Powercord, Keyboard, Mouse
- Centroid tested and pre qualified to work with Centroid CNC controllers
- Compatible with Acorn, Oak, and Allin1DC

___________________________________________

http://www.centroidcnc.com/centroid_diy ... oller.html

Centroid all-in-one Touch Screen CNCPC ready to go $1200 (#11084tb)

- Preloaded with Windows 10 and pre-configured for CNC PC duty
- Preloaded "Centroid Free CNC" software with G code Editor, Intercon, Stock PLC programs, Acorn Install Wizard, Touch Screen Operator Control panel.

Plug in the Acorn board, run the Acorn Wizard and you are good to go.

Re: confused about option

Posted: Fri Aug 04, 2017 7:54 am
by Centroid_Liviu
- Touch Screen Operator Control panel. <--- Is the software option in CNC12 that allows a Touch Screen Control Panel to be used. You can touch your screen to jog, estop, etc. Just like a physical control pendant, but without the cost. A touch screen monitor is required for this.

Either the ALLIN1PC or the NUC PC will work if you want a computer option from us. We are currently updating the website and prices, some pages might show differences. Its the same item though.