Homing Failure
Posted: Wed Jul 26, 2017 5:01 pm
Greetings,
We are putting the finishing touches on an All-in-one installation using CNC11.
It is going well but I can only home the Y axis. It trips the home switch and back off as it should.
But with the X and Z, I get the following sequence.
302 Moving...
327 Fault: job cancelled
411 X axis (1) full power without motion
SV STALL ERROR Reported by CNC11!!!
The axis moves to the switch but the machine shuts down as soon as the switch is tripped.
All the axis use the same NC limit switches. They light up as they should in the I/O screen -- 1, 3, and 6.
Your help is appreciated.
Rich
We are putting the finishing touches on an All-in-one installation using CNC11.
It is going well but I can only home the Y axis. It trips the home switch and back off as it should.
But with the X and Z, I get the following sequence.
302 Moving...
327 Fault: job cancelled
411 X axis (1) full power without motion
SV STALL ERROR Reported by CNC11!!!
The axis moves to the switch but the machine shuts down as soon as the switch is tripped.
All the axis use the same NC limit switches. They light up as they should in the I/O screen -- 1, 3, and 6.
Your help is appreciated.
Rich