Page 1 of 1

Messages during ALLIN1DC Bench Test

Posted: Sun Jul 16, 2017 7:21 pm
by Jay
Hi Gang!
I'm just starting the Bench Test of the AllIN1DC - going through the paces and getting a couple of messages along the way:

The first one: 5161 Unconfigured Mini PLC 1 Found
I have a PLCADD1616 in the mix so not sure it that's generating the message, or if the message is part of the normal process


The second: (going from memory) - Invalid Tool Library / Offset library File
Again I haven't done any trouble shooting yet to see if the files are there, or if they're created later when I define a tool and an offset, or if it's just a Windows permission thing.

Thanks
Jay

Re: Messages during ALLIN1DC Bench Test

Posted: Sun Jul 16, 2017 11:30 pm
by cncsnw
Set Machine Parameter 900 = 1 to tell the software to expect your PLCADD1616 board.

The messages regarding tool and offset libraries will go away once you have gone to those screens and pressed F10/Save for the first time. Likewise, if you are getting a message about the WCS file, you can go to the Part Setup screen and set zero on any axis.

Re: Messages during ALLIN1DC Bench Test

Posted: Mon Jul 17, 2017 11:31 am
by martyscncgarage
Jay wrote: Sun Jul 16, 2017 7:21 pm Hi Gang!
I'm just starting the Bench Test of the AllIN1DC - going through the paces and getting a couple of messages along the way:

The first one: 5161 Unconfigured Mini PLC 1 Found
I have a PLCADD1616 in the mix so not sure it that's generating the message, or if the message is part of the normal process


The second: (going from memory) - Invalid Tool Library / Offset library File
Again I haven't done any trouble shooting yet to see if the files are there, or if they're created later when I define a tool and an offset, or if it's just a Windows permission thing.

Thanks
Jay
Keep us posted on your progress! We're interested to see how you make out.
What machine are you upgrading? Pictures?
Marty

Re: Messages during ALLIN1DC Bench Test

Posted: Mon Jul 17, 2017 7:44 pm
by Jay
cncsnw wrote: Sun Jul 16, 2017 11:30 pm Set Machine Parameter 900 = 1 to tell the software to expect your PLCADD1616 board.
...
Awesome! thanks

I've taken pictures along the way as I've cleaned up this old Bridgeport, and will post them shortly.

Jay

Re: Messages during ALLIN1DC Bench Test

Posted: Mon Sep 18, 2017 11:02 pm
by Jay
Hi Gang - I've posted pictures of the build in the Success stories section of this forum - so far enjoying the work!