What are the dimensions/specs of the encoders Ajax sells?

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
ajaxchris

What are the dimensions/specs of the encoders Ajax sells?

Post by ajaxchris » Wed Mar 17, 2010 4:25 pm

Please see the attached drawings/specs. The shaft sizes available from AjaxCNC are 1/4", 6mm, 3/8", and 1/2" and can be ordered from our CNC Components page: http://www.ajaxcnc.com/cnc_components.htm

Some important amendments/corrections for the PDF spec sheet below:

1. These encoders are for use with DC motors and therefore have no commutation tracks. A DB9 connector will handle all 9 signals.
2. We sell only 4000 line(ppr) = 8000 count/rev in DC encoders.
3. We sell 1/4", 6mm, 3/8", and 1/2" shaft size encoders.
Attachments
ajax_encoder_specs.pdf
(1.72 MiB) Downloaded 476 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest