Is there a brain for the probe? Also do you have a diagram for the pin out for probe connection.\
Thanks
got a probe from me bday
Moderator: cnckeith
-
- Posts: 2
- Joined: Fri Oct 07, 2016 2:04 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: 0917130853
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: got a probe from me bday
Ok after doing the research I should have done before asking a question I now have the pin connections.
My question is that on your diagram you say that the probe pin 3 (white) corresponds with input 772. Is that the same on Mach3 as the pin number when I set up the probe in Mach 3?
My question is that on your diagram you say that the probe pin 3 (white) corresponds with input 772. Is that the same on Mach3 as the pin number when I set up the probe in Mach 3?