Spindle Bench Test

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
kck63
Posts: 6
Joined: Tue Feb 09, 2016 7:32 pm
Allin1DC CNC Controller: Yes
CNC Control System Serial Number: none
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No

Spindle Bench Test

Post by kck63 »

Hi I have a Allin1DC 1106120591 I am trying to run the spindle bench test. I got to about step # 5 and I got a 10 volt reading where it should have been a 2.5 reading. I got a message that said it was out of range and to make sure I/O # 17 are green. I cant change the state of # 17 output to green state. Any ideas ?? THANKS
diycncscott

Re: Spindle Bench Test

Post by diycncscott »

Hello,

When requesting support, please ALWAYS include a current report.zip from your system. It contains hardware, software and configuration information that we need in order to be able to answer you questions. You can post it here or email it to tech@ajaxcnc.com. Please be sure to post/send the report.zip (not report.txt).
Post Reply