Spindle Bench Test
Moderator: cnckeith
-
- Posts: 6
- Joined: Tue Feb 09, 2016 7:32 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Spindle Bench Test
Hi I have a Allin1DC 1106120591 I am trying to run the spindle bench test. I got to about step # 5 and I got a 10 volt reading where it should have been a 2.5 reading. I got a message that said it was out of range and to make sure I/O # 17 are green. I cant change the state of # 17 output to green state. Any ideas ?? THANKS
Re: Spindle Bench Test
Hello,
When requesting support, please ALWAYS include a current report.zip from your system. It contains hardware, software and configuration information that we need in order to be able to answer you questions. You can post it here or email it to tech@ajaxcnc.com. Please be sure to post/send the report.zip (not report.txt).
When requesting support, please ALWAYS include a current report.zip from your system. It contains hardware, software and configuration information that we need in order to be able to answer you questions. You can post it here or email it to tech@ajaxcnc.com. Please be sure to post/send the report.zip (not report.txt).