**RESOLVED** Feed and spindle speed overrides

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Locked
bezelchuck
Posts: 24
Joined: Fri Apr 23, 2010 3:23 pm

**RESOLVED** Feed and spindle speed overrides

Post by bezelchuck »

Hi
I'm steadily retroing a large vmc and am hoping to retain the consoles speed and feed overides rather than use a jog pendant. Is it possible to configure potentiometers to do this? I see in the documentation section of this forum a document about an "Analog I/O Expansion Board", will this do the trick and what does it cost? I'd rather use knobs with positive maximum and minimum end stops rather than an encoder that continues to rotate.
Thanks for any suggestions
Phil
diycncscott

Re: Feed and spindle speed overrides

Post by diycncscott »

Hi Phil,

Yes, you can use our analog I/O expansion board. It includes 4 12bit analog inputs and 4 16bit analog outputs. Price is $250.00
Locked