To any one who get a problem like this please watch for this. My CPU system had this problem of servodive shut down many times, and also screen becoming blank on motor start. I have solved the problem as follows.
The Mother Board of the P4 The Mother computer ( Samsumg) was changed to an American Brand, and lo, the problem solved. Diagnosis:- The Mother Board had a component failure .
Screen get Blanked on spindle motor starting ,Diagnosis:- The Wires coming to the machine too long from the power source and being 200V three Phase, there is a drop of Volts to the CPU and the Monitor.
Hope this helps any one
SERVO DRIVE SHUT DOWN
Moderator: cnckeith
-
- Posts: 4
- Joined: Fri May 01, 2015 5:24 am
- Allin1DC CNC Controller: No
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
-
- Posts: 7287
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: SERVO DRIVE SHUT DOWN
yes..when the CNC PC motherboard shuts down or reboots the control goes into e stop condition.
best to buy the ajax recommended mother board, cpu, ram and SSD
gigabyte motherboard, with Samsung or Intel SSD, cpu with single core benchmark of at least a 1000
http://www.ajaxcnc.com/cnc-pc-minimum-h ... uirements/
best to buy the ajax recommended mother board, cpu, ram and SSD
gigabyte motherboard, with Samsung or Intel SSD, cpu with single core benchmark of at least a 1000
http://www.ajaxcnc.com/cnc-pc-minimum-h ... uirements/
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html