9121 ATC Tool Counter noise
Moderator: cnckeith
-
- Posts: 5
- Joined: Wed Apr 29, 2015 1:45 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
9121 ATC Tool Counter noise
I have my tool counter set up using the geneva switch Normaly open, I can index radomly anywhere for 1 to 8 slots before I get the 9121 ATC tool counter noise error. Any help would be greatly appreciated.
-
- Posts: 7164
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: 9121 ATC Tool Counter noise
make sure the signal wires to the sensor are shielded with a drain to earth ground.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html