Switch encoder direction


LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
Posts: 5
Joined: Wed May 26, 2010 10:14 am

Switch encoder direction

Post by Stjhon » Wed Jun 02, 2010 7:29 am

I am trying to find out how to switch ecoder direction. because I have a mach3 system and putting it on a router table and because of the product being ran on it and the process I need the encoders to read + and - in certain directions.any info would help greatly

Post Reply

Who is online

Users browsing this forum: rl49 and 5 guests