Hitachi WJ200 Inverter Wiring

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
Centroid_Liviu
Posts: 272
Joined: Mon Jul 18, 2011 9:57 am
Allin1DC CNC Controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
System Serial Number: none

Hitachi WJ200 Inverter Wiring

Post by Centroid_Liviu » Thu May 02, 2013 8:33 am

Please follow the table below to connect the Hitachi WJ200-015SF drive. Make sure that there is a jumper installed between pins L and PLC on the inverter. The 0-10VDC COM signal must be connected to the L that is in between the OI and AM pins on the inverter. Make sure that A001 is set to 01 and that A005 is set to 00.
Attachments
Hitachi WJ200 Wiring.JPG

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest